We knit a man a raglan sweater with knitting needles from Drops

We knit a man a raglan sweater with knitting needles from Drops

We knit a man a raglan sweater with knitting needles from Drops

If we are already knitting men warm and comfortable, then raglan sweater for them is probably the most necessary clothes. Embossed patterns of the model are carried out by the most simple facial and purl loops.

The size: S - M - L - XL - XXL - XXXL
Materials: 600-650-750-800-800-900 yrs. DROPS LIMA yarn (65% wool and 35% alpaca, 50 g / 92 m.) Is knitted with a raglan sweater circular (length 80 cm) and bilateral knitting needles 4.0 and 3.5 mm .
Knitting density: 21 p. * 28 p. = 10 * 10 cm with spokes 4.0 mm. Facial smoothness.
Pattern: Scheme 1 and Scheme 2
Decrements for raglan: Knit up to 3 loops before the label, 2 together faces. For the rear wall, 1 dep., The mark, 1 dep., 2 together persons.
Attention! Observe the density of knitting both in width and inHeight, if you knit too tight, raglan will turn out to be too short, and so the armholes are too small; If this happens, add a few rows without any penalty.

We knit a raglan sweater for men:

Before and back: On the circular needles 3.5 mm. Dial 232-252-272-296-320-360 loops, connect in a circular row, knit in a circle rubber band 2 persons., 2 out. - 4 cm.
Go for circular knitting needles 4.0 mm., Knit a series of facial loops, simultaneously reduce 48-52-56-60-64-72 loops along this row = 184-200-216-236-256-288 loops.
Add 2 labels on the sides - 92-100-108-118-128-144 loops between the marks.
Continue to knit with the facial smoothness (when knitting in a circle all the rows perform facial loops) - 6 cm.
Add on each side a label of 1 loop (4 loops added).
Repeat the increments at an altitude of 15-16-17-18-19-20 cm, then at an altitude of 24-25-26-27-28-29 cm = 196-212-228-248-268-300 loops.
Continue to knit with facial smoothness to a height of 26-27-28-29-30-31 cm.
Knit 6 rows according to scheme 1
Then knit 10 cm according to Scheme 2
Knit 6 rows according to scheme 1
Continue to knit in Scheme 2 throughout the work.
Lappes: at the height of the parts 44-45-46-47-48-49 see close 4 hinges on each side of the mark = on 90-98-106-116-126-142 for the transfer and for the back, postpone the work and take hold of the sleeves .

Sleeve: On double-faced spokes 3.5 mm. Dial 68-68-72-72-76-76 loops, connect in a circular row, knit in a circle rubber band 2 persons., 2 out. - 4 cm.
Go for double-sided needles 4.0 mm., Knit the series with facial loops, and at the same time lower 14-12-14-12-14-12 loops along this row = 54-56-58-60-62-64 loops.
Add a mark in the beginning of the circular row - this is the middle place of the seam of the sleeve.

Continue to knit with facial smoothness - 8 cm.
Add 1 loops on each side of the label
Repeat such increases every 11-8-7-6-4-3.5 cm. - 4-5-6-7-10-11 times = 64-68-72-76-84-88
At the same time, at the height of 37-37-36-36-35-35, knit 6 rows of scheme 1
Then knit 10 cm according to Scheme 2
Knit 6 rows according to scheme 1
Continue to knit in Scheme 2 throughout the work.
Polaris: at the height of the details 55-55-54-54-53-53 cm. (Adjust the work so that you were on the same row of the circuit as the backrest when the armpits closed) close 4 loops on each side of the mark = 56-60-64-68-76-80 loops.
Put off the hinges, tie the second sleeve.

We knit a sweater for men with a round yoke: Place the hinges of the sleeves on the spokes of the gear and the backrest in place of the closed hinges for the armhole = 292-316-340-368-404-444 loops.
Before you begin, read the description to the end.
Continue to knit in accordance with scheme 2, to the height of the detail 46-47-48-49-50-51
Add loop marks to all transitions from the main part to the sleeves (4 marks)
Decrease for raglan: Reduce 1 loop (as before and after the mark, see above) after the 2nd and 4th marks and before the 3rd and 1st marks (decrease of the hinges of the sleeve) in each 4th row - 7-7-6-6- 4-2 times, then in each 2-nd row - 12-14-17-19-25-29 times.
Then lower 1 loop after the 1st and 3rd marks and before the 2nd and 4th coil (the reduction of the loops of the gear and the back) in each 2nd row - 24-24-25-25-25-22 times, Then in each row - 3-5-6-9-12-21 times.
SIMULTANEOUSLY at the height of the detail 59-61-63-65-67-69 see, close for the neck central 10-14-18-22-26-30 loops.
Knit there and back, close each side of the neck in every second row 2 loops - 2 times and 1 loop - 1 time.
After all the deductions = 82-86-90-94-98-102 loops.
Knit a series of facial loops, and reduce 12-14-16-18-20-22 loops along this row = 70-72-74-76-78-80 loops.

Threading: Knit with knitting needles 3.5 mm. From the front side 70-72-74-76-78-80 loops, then dial 54-56-58-60-62-64 loops along the neck of the transfer = 124-128-132-136-140-144 loops, connect in a circular row.
Knit 2 rows of facial loops.
Knit 2 rows of purl loops.
Then knit with elastic band 2 persons., 2 out. - 3.5 cm.
Close the faces. Over the facial and ext. Over the purl.

Assembly: Sew holes between the sleeves and the yoke.